Based on the analysis of various aspects such as punching force, mold structure, and height in the actual manufacturing process, the application of existing manufacturing facilities is closely related to the design of molds. It is necessary to develop rel
Semi automatic and manual punching machines are equipped with dual hand brake switches, and it is strictly prohibited to press with foot pedals or single hand start switches.
The unreasonable structural design of stamped parts determines the low material utilization rate, and due to the low material utilization rate caused by the structural design of stamped parts, it cannot be improved. The shape of stamped parts determines t
Process supplementation is an important component of the stamping die surface, and its shape affects material utilization.
Metal stamping parts have high dimensional accuracy, uniform and consistent dimensions with the same module, and good interchangeability. It can meet general assembly and usage requirements without further mechanical processing.
During stamping processing, the accuracy level of hole positioning should be higher than that of shape positioning. Therefore, in the process design of stamping parts, hole positioning should be used as much as possible, and the consistency of positioning
